UDT mod standard - mechanical mod 18650/18350
The UDT standard mod is a mechanical mod from Youde, the manufacturer of the AGA T2 and many other rebuildable atomizers. The UDT-S is designed to be used with two 18350 batteries or one 18650 battery .
The UDT standard mod is made of a very thin stainless steel and has a soft, muted finish. This is definitely NOT a finger print magnet. This mod has full, exposed EGO threads so virtually all EGO and 510-threaded devices will fit.
The UDT standard mod is a fully mechanical mod. There are no electronics controlling or limiting the voltage being supplied to the atomizer. As such, when you insert a fresh cell, you will be getting approximately 4.2 volts (unloaded voltage). This will slowly decrease as you discharge the battery.
Because of the mechanical nature of the device, there is no over discharge protection. If you are using IMR or IFR cells or unprotected ICR cells (not recommended) be sure not to over discharge them. You could ruin the cells or even worse have a cell failure that could cause an explosion or fire.
There are also no other protection circuits like there are in APVs with electronic switches. Atomizing devices that short circuit can ruin the device and or your batteries. This is an advanced user device. Please be sure you understand enough about batteries and circuits before you use it.
Technical specifications :
There are currently no product reviews.
Write Review