Smoktech GROOVE 2 VV/VW 3800mah battery MOD
This is the New Groove 2 from Smoktech . The problems with some version 1 groove mods have been solved .
This is a variable voltage, variable wattage box mod. the Groove adjusts from 3.0 to 6.0 Volts in 0.1 volt increments or 3.0 to 15 Watts in .5 Watt increments and has a small back lit OLED display. The Groove has a maximum output of 5 Amps.
The Groove can read your output voltage, battery voltage and cartomizer / atomizer resistance.
The 510 connector will accept any 510 tank, atomizer or cartomizer and has a channel around the 510 connector so you can use 510 eGo style cartomizers or tanks. With the power of variable voltage you can use almost any 510 tank or carto you have.
There are ample vent holes in the backside of this APV for added safety.
The groove has an internal 3.7V, 3800mAh Li-polymer battery that will last for days as opposed to hours. The Groove cannot be used while it is being recharged.
The kit include the following :
-
GROOVE 3800mah Mod body in chrome
-
USB Cable
-
Wall adapter
-
Instructions manual color
-
Presentation box
More details :
-
3800mah Li-polymer 3.7v battery mod
-
3.0v - 6.0v variable voltage in 0.1 increments
-
3.0W - 15.0W variable wattage in 0.5 increments
-
Cycles around once it reaches either end of voltage or wattage.
-
Can detect atomizer resistance by pressing the "+" button for three seconds.
-
Can detect battery remaining voltage by pressing the "-" button for three seconds.
-
5 clicks of fire button turns the unit on and off.
-
Holding both "+" and "-" buttons together for three seconds toggles between variable voltage and variable wattage
-
RMS output
-
Micro USB port on the groove connects either to included wall adapter or can be attached to a high power USB port on your computer for charging.
-
It takes about 4 hours for a full charge.
-
OLED screen
-
Large Double Venting in the back
-
FORCED RESET FEATURE: If you are experiencing abnormal behavior simply press the S1(the "-" button) and the S3 (fire button on top) together for ten seconds, when you see the SMOK letterign coem up you have successfully reset the mod.
-
5 AMP limit
-
Low Battery Protection
-
SHORT CIRCUIT PROTECTION: The mod will warn you with a short circuit message on the screen when you press the firing button atop the mod.
-
Lowest resistance atomizer is 1.0 ohms;
-
Highest resistance is 5.0 ohms.
There are currently no product reviews.
Write Review