Lavatube kit 4.0 is an ultimate generation product , easy to use , both for beginers and experienced users .
The kit contains the following :
- Lavatube body 4.0 made of Chrome
- one High Voltage Atomizer
- Two Lavatube batteries 18650 with a capacity of 1700 mAh each .
- One TrustFire TR002 Charger
- Chromed Drip Tip
- Case
- Manul with instructions
The voltage can be adjusted between 3 V and 6 V with 0,1 V .
The adjustment can be made by pressing "+" and "-" buttons to increase or decrease the voltage with 0.1 V .To lock the voltage at a specific value you need to keep pressed both buttons 5 seconds . To unlock the voltage you need to do the same .
To check the atomizer's resistance press Shortly and simultaneously the Power button and one of the buttons "+" or "-" for 5 times and the display will show the value of atomizer`s resistance mounted on Lavatube 4.0.
Features
- Compatible with almost all atomizers and cartomizers.
- It can take low resistance atomizer's from: 1.0-5.0ohms
- ego and 510 connection
- Length : 130 mm
- Diameter : 22 mm
- Brand : L-Rider
- Model : EpicStorm Lambo v4
- Certificates : CE,RoHS,UL,UN38.3
- Made from Chrome .
-
The Lavatube Body has an LCD screen which shows the voltage and the remaining power of the battery .Has the ability to check the battery voltage
-
Support and maximum 9amps out put current.
- Protected agains over-heating
- Protected against short-circuit
- Protected agains battery inversion
- Tension protection
- Hole for gas evacuation
We have 4 buttons on the exterior housing of the Electronic Cigarette
- -Power button (Red)
- -Fire button
- -2 buttones to adjust the voltage(+ and -)
Power button ( Red )
-It has 5 click protection function ,wich means you need to push 5 times the button in 2 seconds to turn on/off the battery.
Fire button
-After you turn on the battery , by pressing this button you will turn on the atomizer at the voltage you had set.
+ and – Buttons
-Are used to adjust the voltage by 0,1 V. If yiu reach at 6 V and press "+" the voltage will be 3 V.
The LCD Screen is easy to use and it indicate the voltage you had set.
In addition the Lavatube corp has a "block" function , which blocks the voltage level to a certain value, eliminating the risk of changing the voltage from mistake.To lock or unlock the voltage voltage you must press the "+" and "-" simultaneously for 5 seconds.
