2013 E-Pipe MODEL
E-601 Electronic Pipe Starter kit
This is the latest model of electronic Pipe with the possibility to change the cartomizer . This will save both time and money because you will change only the cartomizer when it does not work anymore and not the whole body of the pipe .
E-601 Starter kit uses a Li-ion 18350 battery with a capacity of 900mah .
A fully charged battery can support up to 800-900 puffs.
WARNING: The battery can damage the pipe if it is mounted in the wrong direction. Please check battery polarity when inserting it into the e-pipe body.
You can use dse601-c cartomizers or any 510 cartomizers with eGo thread which fits the E-Pipe slot for cartomizers .
The kit contains the following :
- 1 X wooden e-pipe body
- 1 X black mouthpiece
- 5 X DSE601-C cartomizers with 510 connector
- 2 X 18350 batteries with a capacity of 900mah
- 1 X Charger for batteries
- 1 X instruction manual
Specifications :
- Pipe length: 156mm
- Pipe Weight: 99 g
- Output voltage: 3.3V-4.2V;
- Battery time is about 3.5-4 hours
- Cartomizers compartment size: Length = 40mm, diameter = 9.2mm;
- Cartomizers Color: matte black;
- Cartomizers Volume: 0.9ml (200-230 puffs);
- Cartomizers Resistance: 2.1-2.4 ohm;
How to use it ?
Install the battery and the cartomizer on the Pipe .
If you installed the battery correctly the LED will blink once in green .
When you will use the Electronic Pipe the LED will light up in red , and when the E-pipe is in stand-by ( you don't use it ) the LED will turn off .
When the battery voltage falls below 3.4V the LED will flash to indicate low power level.
How to charge the batteries ?
Put the battery into the charger when you want to charge it .
LED on the charger is red when the battery is charging and turns green when the battery is fully charged.
When charging the battery, please make sure that the polarity of the charger and battery is the same.
