Aspire Nautilus pyrex Tank Clearomizer with 5ml capacity

The Aspire Nautilus clearomizer has an exclusive adjustable airflow design that is revolutionary. With a simple turn of the lower ring, you have four options to adjust airflow to meet different requirements for vaping. With the option of different size air-ports, it allows the user to produce big clouds of vapor, with a pure and clean taste. With the Nautilus four-port system, you can now adjust how hard or soft the drag is, how warm or cold the vapor is, and how much vapor is produced. The Nautilus is also very easy to install and refill. Oh, and the most important thing of all, it allows you to adjust your tank to accomodate for different eliquids!

• 1 X Complete Nautilus tank (1.6ohm resistance pre-installed)
• 1 X replacement dual coil resistance
• 1 X eGo threaded cone
• 1 X user manual in english

• Stainless Steel
• Adjustable Airflow Control
• 5ml Capacity
• Threaded pyrex glass tube
• BDC (Bottom Dual Coil) Technology
• Height of  Nautilus Tank System:83.65mm
• Max Diameter of Nautilus Tank System:23.45mm
• Height of Nautilus Replaceable Coil :25.7mm
• Max Diameter of Nautilus Replaceable Coil :10mm
• Max Diameter of Nautilus Replaceable Coil :10mm

• Ø0.9mm
• Ø1.1mm
• Ø1.4mm
• Ø1.8mm

• 1.6ohm  (3.3v-5.0v)
• 1.8ohm (3.3v-6.0v)

• To fill, turn the tank upside down and remove the threaded end cap.  Fill the outer portion of the tank (avoid getting e-liquid into the center airflow tube) and then screw the end cap back onto the tank tightly.  You can now turn it rightside up and check for leaks before using.
• Gurgling or Leaking can occur if liquid gets into the center airflow tube.  To clear this liquid and improve performance remove the tank from the battery and blow through the mouthpiece into a paper towel.  The excess liquid will come out of the threaded end of the device.  If this happens often you may need to check that all connections are screwed down tightly or replace the head and wick assembly with a new one.
• The head and wick assembly will sometimes loosen itself when the threaed end cap is unscrewed.  Always check that it is pushed into the bottom cap tightly tightly before screwing the cap back on.  Not doing so could result in a leaking or non-working device.
• You should never run the tank completely dry.  Doing so could result in a burnt or damaged wick and can cause leaking.  Refill the tank when the liquid level reaches approximately 1/3 full
• The lifespan of replacement heads can vary quite a bit, but following the above instructions will maximize the lifespan of the coil.

You can find here additional resistances for Aspire Nautilus clearomizer :

Replaceable head coil for Aspire Nautilus clearomizer